[media] go7007: tuner/std related fixes
- The Adlink is initially detected as a sensor board, so the driver config
is set up as if it was a sensor. Later the driver discovers that it really
is a video capture card and that means that the driver configuration has
to be updated for a PAL/NTSC capture card.
- Setup the correct initial std based on the TV tuner type.
- Remember the exact std the user selected, don't map it to STD_PAL or NTSC.
- Use v4l2_disable_ioctl to disable ioctls based on the board config and
drop a lot of checking code in each of those ioctls since that is no longer
needed.
- enum_input should use tvnorms to fill its std field.
- configure the input, std and initial tuner frequency at driver initialization.
- fix std handling in the s2250 driver.
- the code handling scaling for devices without a scaler was broken. This is
now fixed.
- correctly set readbuffers and capability in g/s_parm.
- remove the bogus test for capturemode in s_parm.
- correctly implement enum_framesizes/intervals.
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
This page took 0.025263 seconds and 5 git commands to generate.