iscsi-target: ST response on IN6ADDR_ANY socket
Odd little issue, found that if you create an IPv6 portal bound to the
IN6ADDR_ANY wildcard address it will accept IPv4 connections (as long as
bindv6only isn't set globally) but respond to SendTargets requests with
an IPv4-mapped IPv6 address.
Example over loopback:
In targetcli create a wildcard IPv6 portal
/iscsi/iqn.../portals/> create ::
Which should create a portal [::]:3260
Initiate SendTargets discovery to the portal using an IPv4 address
# iscsiadm -m discovery -t st -p 127.0.0.1
The response formats TargetAddress as [::ffff:127.0.0.1]:3260,1
This still works and uses v4 on the network between two v6 sockets, but
only if the initiator supports IPv6 with v4-mapped addresses.
This change detects v4-mapped address on v6 sockets for the wildcard
case, and instead formats the TargetAddress response as an IPv4 address.
In order to not further complicate iscsit_build_sendtargets_response,
I've actually simplified it by moving the bracket wrapping of IPv6
address into iscsit_accept_np where local_ip and login_ip strings are
set. That also simplifies iscsi_stat_tgt_attr_show_attr_fail_intr_addr.
Side effect of the string format change is that
lio_target_nacl_show_info will now print login_ip bracket wrapped for
IPv6 connections, as will a few debug prints.
Signed-off-by: Chris Leech <cleech@redhat.com>
Signed-off-by: Nicholas Bellinger <nab@linux-iscsi.org>
This page took 0.024739 seconds and 5 git commands to generate.