When an interrupt occurs, the INT pin is driven low by the
MCP251x controller (falling edge) but in some cases the INT
pin can be connected to the MPU through a transistor or level
translator which inverts this signal. In this case interrupt
should be configured in rising edge.
This patch adds support to pass the IRQ flags via
mcp251x_platform_data.
Signed-off-by: Enric Balletbo i Serra <eballetbo@iseebcn.com>
Acked-by: Wolfgang Grandegger <wg@grandegger.com>
Acked-by: Marc Kleine-Budde <mkl@pengutronix.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
priv->tx_len = 0;
ret = request_threaded_irq(spi->irq, NULL, mcp251x_can_ist,
priv->tx_len = 0;
ret = request_threaded_irq(spi->irq, NULL, mcp251x_can_ist,
- IRQF_TRIGGER_FALLING, DEVICE_NAME, priv);
+ pdata->irq_flags ? pdata->irq_flags : IRQF_TRIGGER_FALLING,
+ DEVICE_NAME, priv);
if (ret) {
dev_err(&spi->dev, "failed to acquire irq %d\n", spi->irq);
if (pdata->transceiver_enable)
if (ret) {
dev_err(&spi->dev, "failed to acquire irq %d\n", spi->irq);
if (pdata->transceiver_enable)
/**
* struct mcp251x_platform_data - MCP251X SPI CAN controller platform data
* @oscillator_frequency: - oscillator frequency in Hz
/**
* struct mcp251x_platform_data - MCP251X SPI CAN controller platform data
* @oscillator_frequency: - oscillator frequency in Hz
+ * @irq_flags: - IRQF configuration flags
* @board_specific_setup: - called before probing the chip (power,reset)
* @transceiver_enable: - called to power on/off the transceiver
* @power_enable: - called to power on/off the mcp *and* the
* @board_specific_setup: - called before probing the chip (power,reset)
* @transceiver_enable: - called to power on/off the transceiver
* @power_enable: - called to power on/off the mcp *and* the
struct mcp251x_platform_data {
unsigned long oscillator_frequency;
struct mcp251x_platform_data {
unsigned long oscillator_frequency;
+ unsigned long irq_flags;
int (*board_specific_setup)(struct spi_device *spi);
int (*transceiver_enable)(int enable);
int (*power_enable) (int enable);
int (*board_specific_setup)(struct spi_device *spi);
int (*transceiver_enable)(int enable);
int (*power_enable) (int enable);