Correct spelling typo in drivers/mfd
Signed-off-by: Masanari Iida <standby24x7@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
/*
* Delay might be needed for ABB8500 cut 3.0, if not, remove
/*
* Delay might be needed for ABB8500 cut 3.0, if not, remove
- * when hardware will be availible
+ * when hardware will be available
if (i2c->irq) {
ret = rc5t583_irq_init(rc5t583, i2c->irq, pdata->irq_base);
if (i2c->irq) {
ret = rc5t583_irq_init(rc5t583, i2c->irq, pdata->irq_base);
- /* Still continue with waring if irq init fails */
+ /* Still continue with warning, if irq init fails */
if (ret)
dev_warn(&i2c->dev, "IRQ init failed: %d\n", ret);
else
if (ret)
dev_warn(&i2c->dev, "IRQ init failed: %d\n", ret);
else
- * RDC321x MFD southbrige driver
+ * RDC321x MFD southbridge driver
*
* Copyright (C) 2007-2010 Florian Fainelli <florian@openwrt.org>
* Copyright (C) 2010 Bernhard Loos <bernhardloos@googlemail.com>
*
* Copyright (C) 2007-2010 Florian Fainelli <florian@openwrt.org>
* Copyright (C) 2010 Bernhard Loos <bernhardloos@googlemail.com>
ret = comp_threshold_set(tps65910, COMP2, pdata->vmbch2_threshold);
if (ret < 0) {
ret = comp_threshold_set(tps65910, COMP2, pdata->vmbch2_threshold);
if (ret < 0) {
- dev_err(&pdev->dev, "cannot set COMP2 theshold\n");
+ dev_err(&pdev->dev, "cannot set COMP2 threshold\n");
/**
* struct max8998_board - packages regulator init data
* @regulators: array of defined regulators
/**
* struct max8998_board - packages regulator init data
* @regulators: array of defined regulators
- * @num_regulators: number of regultors used
+ * @num_regulators: number of regulators used
* @irq_base: base IRQ number for max8998, required for IRQs
* @ono: power onoff IRQ number for max8998
* @buck_voltage_lock: Do NOT change the values of the following six
* @irq_base: base IRQ number for max8998, required for IRQs
* @ono: power onoff IRQ number for max8998
* @buck_voltage_lock: Do NOT change the values of the following six