- /* The LVDS pin pair needs to be on before the DPLLs are enabled.
- * This is an exception to the general rule that mode_set doesn't turn
- * things on.
- */
- if (is_lvds) {
- temp = I915_READ(PCH_LVDS);
- temp |= LVDS_PORT_EN | LVDS_A0A2_CLKA_POWER_UP;
- if (HAS_PCH_CPT(dev)) {
- temp &= ~PORT_TRANS_SEL_MASK;
- temp |= PORT_TRANS_SEL_CPT(pipe);
- } else {
- if (pipe == 1)
- temp |= LVDS_PIPEB_SELECT;
- else
- temp &= ~LVDS_PIPEB_SELECT;
- }
-
- /* set the corresponsding LVDS_BORDER bit */
- temp |= dev_priv->lvds_border_bits;
- /* Set the B0-B3 data pairs corresponding to whether we're going to
- * set the DPLLs for dual-channel mode or not.
- */
- if (clock.p2 == 7)
- temp |= LVDS_B0B3_POWER_UP | LVDS_CLKB_POWER_UP;
- else
- temp &= ~(LVDS_B0B3_POWER_UP | LVDS_CLKB_POWER_UP);
-
- /* It would be nice to set 24 vs 18-bit mode (LVDS_A3_POWER_UP)
- * appropriately here, but we need to look more thoroughly into how
- * panels behave in the two modes.
- */
- temp &= ~(LVDS_HSYNC_POLARITY | LVDS_VSYNC_POLARITY);
- if (adjusted_mode->flags & DRM_MODE_FLAG_NHSYNC)
- temp |= LVDS_HSYNC_POLARITY;
- if (adjusted_mode->flags & DRM_MODE_FLAG_NVSYNC)
- temp |= LVDS_VSYNC_POLARITY;
- I915_WRITE(PCH_LVDS, temp);
- }
-