scsi: ufs: add missing memory barriers
authorYaniv Gardi <ygardi@codeaurora.org>
Mon, 1 Feb 2016 13:02:48 +0000 (15:02 +0200)
committerMartin K. Petersen <martin.petersen@oracle.com>
Wed, 24 Feb 2016 02:27:02 +0000 (21:27 -0500)
Performing several writes to UFS host controller registers has no
guarantee of ordering, so we must make sure register writes to setup
request list base address etc. are performed before the run/stop
register is enabled.  In addition, when setting up a task request, we
must make sure the updating of descriptors takes places before ringing
the doorbell, similarly to setting up a transfer request.

Reviewed-by: Dolev Raviv <draviv@codeaurora.org>
Signed-off-by: Gilad Broner <gbroner@codeaurora.org>
Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>
drivers/scsi/ufs/ufshcd.c

index a1e9d82716a69b318aec35280859191985981a00..1893a14f231ef1ced201bf4ad04b05db73f4ed33 100644 (file)
@@ -400,11 +400,9 @@ static inline int ufshcd_get_lists_status(u32 reg)
         *  1           UTRLRDY
         *  2           UTMRLRDY
         *  3           UCRDY
-        *  4           HEI
-        *  5           DEI
-        * 6-7          reserved
+        * 4-7          reserved
         */
-       return (((reg) & (0xFF)) >> 1) ^ (0x07);
+       return ((reg & 0xFF) >> 1) ^ 0x07;
 }
 
 /**
@@ -2724,7 +2722,7 @@ out:
  * To bring UFS host controller to operational state,
  * 1. Enable required interrupts
  * 2. Configure interrupt aggregation
- * 3. Program UTRL and UTMRL base addres
+ * 3. Program UTRL and UTMRL base address
  * 4. Configure run-stop-registers
  *
  * Returns 0 on success, non-zero value on failure
@@ -2753,9 +2751,14 @@ static int ufshcd_make_hba_operational(struct ufs_hba *hba)
        ufshcd_writel(hba, upper_32_bits(hba->utmrdl_dma_addr),
                        REG_UTP_TASK_REQ_LIST_BASE_H);
 
+       /*
+        * Make sure base address and interrupt setup are updated before
+        * enabling the run/stop registers below.
+        */
+       wmb();
+
        /*
         * UCRDY, UTMRLDY and UTRLRDY bits must be 1
-        * DEI, HEI bits must be 0
         */
        reg = ufshcd_readl(hba, REG_CONTROLLER_STATUS);
        if (!(ufshcd_get_lists_status(reg))) {
@@ -3918,6 +3921,10 @@ static int ufshcd_issue_tm_cmd(struct ufs_hba *hba, int lun_id, int task_id,
 
        /* send command to the controller */
        __set_bit(free_slot, &hba->outstanding_tasks);
+
+       /* Make sure descriptors are ready before ringing the task doorbell */
+       wmb();
+
        ufshcd_writel(hba, 1 << free_slot, REG_UTP_TASK_REQ_DOOR_BELL);
 
        spin_unlock_irqrestore(host->host_lock, flags);
This page took 0.027219 seconds and 5 git commands to generate.