atmel_serial: fix internal port num

the atmel_ports is link to the console number and not the device id

this was not detected on at91 as we always register the dbgu on the console
as ttyS0

tested on at91sam9263 by setting the dbgu as ttyS1 and use as console

diff --git a/arch/arm/mach-at91/board-sam9263ek.c b/arch/arm/mach-at91/board-sam9263ek.c
index 70e5646..9b8a14f 100644
- a/arch/arm/mach-at91/board-sam9263ek.c
+ b/arch/arm/mach-at91/board-sam9263ek.c
@@ -58,14 +58,14 @@ static void __init ek_init_early(void)
        /* Initialize processor: 16.367 MHz crystal */
        at91_initialize(16367660);

-       /* DBGU on ttyS0. (Rx & Tx only) */
-       at91_register_uart(0, 0, 0);
+       /* DBGU on ttyS1. (Rx & Tx only) */
+       at91_register_uart(0, 1, 0);

-       /* USART0 on ttyS1. (Rx, Tx, RTS, CTS) */
-       at91_register_uart(AT91SAM9263_ID_US0, 1, ATMEL_UART_CTS | ATMEL_UART_RTS);
+       /* USART0 on ttyS0. (Rx, Tx, RTS, CTS) */
+       at91_register_uart(AT91SAM9263_ID_US0, 0, ATMEL_UART_CTS | ATMEL_UART_RTS);

-       /* set serial console to ttyS0 (ie, DBGU) */
-       at91_set_serial_console(0);
+       /* set serial console to ttyS1 (ie, DBGU) */
+       at91_set_serial_console(1);
 }

 /*

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre@atmel.com>
Cc: Alan Cox <alan@linux.intel.com>
Cc: Hans-Christian Egtvedt <hans-christian.egtvedt@atmel.com>

diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index 6d5d6e679fc7f59c568a0a1afbac800e51f91e49..af9b7814965a461921d337047c068aed9bb5d051 100644 (file)
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -1709,12 +1709,13 @@ static int atmel_serial_resume(struct platform_device *pdev)
 static int __devinit atmel_serial_probe(struct platform_device *pdev)
 {
        struct atmel_uart_port *port;
+       struct atmel_uart_data *pdata = pdev->dev.platform_data;
        void *data;
        int ret;
 
        BUILD_BUG_ON(ATMEL_SERIAL_RINGSIZE & (ATMEL_SERIAL_RINGSIZE - 1));
 
-       port = &atmel_ports[pdev->id];
+       port = &atmel_ports[pdata->num];
        port->backup_imr = 0;
 
        atmel_init_port(port, pdev);