From: Stephen M. Cameron Date: Fri, 14 Sep 2012 21:34:25 +0000 (-0500) Subject: [SCSI] hpsa: fix handling of protocol error X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=256d0eaac87da1e993190846064f339f4c7a63f5;p=deliverable%2Flinux.git [SCSI] hpsa: fix handling of protocol error If a command status of CMD_PROTOCOL_ERR is received, this information should be conveyed to the SCSI mid layer, not dropped on the floor. CMD_PROTOCOL_ERR may be received from the Smart Array for any commands destined for an external RAID controller such as a P2000, or commands destined for tape drives or CD/DVD-ROM drives, if for instance a cable is disconnected. This mostly affects multipath configurations, as disconnecting a cable on a non-multipath configuration is not going to do anything good regardless of whether CMD_PROTOCOL_ERR is handled correctly or not. Not handling CMD_PROTOCOL_ERR correctly in a multipath configaration involving external RAID controllers may cause data corruption, so this is quite a serious bug. This bug should not normally cause a problem for direct attached disk storage. Signed-off-by: Stephen M. Cameron Cc: stable@vger.kernel.org Signed-off-by: James Bottomley --- diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c index 796482badf13..2b4261cb7742 100644 --- a/drivers/scsi/hpsa.c +++ b/drivers/scsi/hpsa.c @@ -1315,8 +1315,9 @@ static void complete_scsi_command(struct CommandList *cp) } break; case CMD_PROTOCOL_ERR: + cmd->result = DID_ERROR << 16; dev_warn(&h->pdev->dev, "cp %p has " - "protocol error \n", cp); + "protocol error\n", cp); break; case CMD_HARDWARE_ERR: cmd->result = DID_ERROR << 16;