From: Emmanuel Grumbach Date: Wed, 8 Jun 2016 20:07:31 +0000 (+0300) Subject: iwlwifi: pcie: enable interrupts before releasing the NIC's CPU X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=2aabdbdc17b7c53490337bfc58de3409c84d85d2;p=deliverable%2Flinux.git iwlwifi: pcie: enable interrupts before releasing the NIC's CPU The NIC's CPU gets started after the firmware has been written to its memory. The first thing it does is to send an interrupt to let the driver know that it is running. In order to get that interrupt, the driver needs to make sure it is not masked. Of course, the interrupt needs to be enabled in the driver before the CPU starts to run. I mistakenly inversed those two steps leading to races which prevented the driver from getting the alive interrupt from the firmware. Fix that. Cc: [4.5+] Fixes: a6bd005fe92 ("iwlwifi: pcie: fix RF-Kill vs. firmware load race") Signed-off-by: Emmanuel Grumbach Signed-off-by: Luca Coelho --- diff --git a/drivers/net/wireless/intel/iwlwifi/pcie/trans.c b/drivers/net/wireless/intel/iwlwifi/pcie/trans.c index 3badebb0febf..ac623c3e3f24 100644 --- a/drivers/net/wireless/intel/iwlwifi/pcie/trans.c +++ b/drivers/net/wireless/intel/iwlwifi/pcie/trans.c @@ -801,6 +801,8 @@ static int iwl_pcie_load_cpu_sections_8000(struct iwl_trans *trans, *first_ucode_section = last_read_idx; + iwl_enable_interrupts(trans); + if (cpu == 1) iwl_write_direct32(trans, FH_UCODE_LOAD_STATUS, 0xFFFF); else @@ -980,6 +982,8 @@ static int iwl_pcie_load_given_ucode(struct iwl_trans *trans, iwl_pcie_apply_destination(trans); } + iwl_enable_interrupts(trans); + /* release CPU reset */ iwl_write32(trans, CSR_RESET, 0); @@ -1215,7 +1219,6 @@ static int iwl_trans_pcie_start_fw(struct iwl_trans *trans, ret = iwl_pcie_load_given_ucode_8000(trans, fw); else ret = iwl_pcie_load_given_ucode(trans, fw); - iwl_enable_interrupts(trans); /* re-check RF-Kill state since we may have missed the interrupt */ hw_rfkill = iwl_is_rfkill_set(trans);