From: Stanimir Varbanov Date: Mon, 11 Apr 2016 08:38:41 +0000 (+0300) Subject: dmaengine: qcom: bam_dma: add controlled-remotely dt property X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=5172c9eb89d4ea41f86ff91b15b2b0dc75ded869;p=deliverable%2Flinux.git dmaengine: qcom: bam_dma: add controlled-remotely dt property Some of the peripherals has bam which is controlled by remote processor, thus the bam dma driver must avoid register writes which initialise bam hw block. Those registers are protected from xPU block and any writes to them will lead to secure violation and system reboot. Adding the contolled_remotely flag in bam driver to avoid not permitted register writes in bam_init function. Signed-off-by: Stanimir Varbanov Reviewed-by: Andy Gross Tested-by: Pramod Gurav Signed-off-by: Vinod Koul --- diff --git a/drivers/dma/qcom/bam_dma.c b/drivers/dma/qcom/bam_dma.c index 789d5f836bf7..d0f878a78fae 100644 --- a/drivers/dma/qcom/bam_dma.c +++ b/drivers/dma/qcom/bam_dma.c @@ -387,6 +387,7 @@ struct bam_device { /* execution environment ID, from DT */ u32 ee; + bool controlled_remotely; const struct reg_offset_data *layout; @@ -1042,6 +1043,9 @@ static int bam_init(struct bam_device *bdev) val = readl_relaxed(bam_addr(bdev, 0, BAM_NUM_PIPES)); bdev->num_channels = val & BAM_NUM_PIPES_MASK; + if (bdev->controlled_remotely) + return 0; + /* s/w reset bam */ /* after reset all pipes are disabled and idle */ val = readl_relaxed(bam_addr(bdev, 0, BAM_CTRL)); @@ -1129,6 +1133,9 @@ static int bam_dma_probe(struct platform_device *pdev) return ret; } + bdev->controlled_remotely = of_property_read_bool(pdev->dev.of_node, + "qcom,controlled-remotely"); + bdev->bamclk = devm_clk_get(bdev->dev, "bam_clk"); if (IS_ERR(bdev->bamclk)) return PTR_ERR(bdev->bamclk);