From: Gregory Herrero Date: Tue, 22 Sep 2015 13:16:50 +0000 (+0200) Subject: usb: dwc2: host: wait 3ms for controller stabilization X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=5634e016cf6e2e0c9651081f5c554f59e1050fc5;p=deliverable%2Flinux.git usb: dwc2: host: wait 3ms for controller stabilization Some high speed mass storage devices fail to enumerate with following error: Cannot enable port %i. Maybe the USB cable is bad? This happens only when the device is plugged while the controller is in hibernation state. After exiting hibernation, the controller detects the device as a low speed device and fail to enumerate it. Problem occurs only if HPRT0.PWR bit is programmed in a too short delay after exiting hibernation. Dumping hprt register in _dwc2_hcd_resume() directly after dwc2_exit_hibernation() shows that HPRT0.LNSTS (D+/D- level) becomes valid approximately 2ms after exiting hibernation. Since dwc2_exit_hibernation() is called from atomic context, move the delay out of this function. Delay value is experimental and not mentioned in Synopsys documentation. To be on the safe side 3ms delay is used. Signed-off-by: Gregory Herrero Signed-off-by: Mian Yousaf Kaukab Tested-by: Robert Baldyga Tested-by: Dinh Nguyen Tested-by: John Youn Acked-by: John Youn Signed-off-by: Felipe Balbi --- diff --git a/drivers/usb/dwc2/hcd.c b/drivers/usb/dwc2/hcd.c index de9d2e2bbf48..65044daddc13 100644 --- a/drivers/usb/dwc2/hcd.c +++ b/drivers/usb/dwc2/hcd.c @@ -2472,6 +2472,9 @@ static int _dwc2_hcd_resume(struct usb_hcd *hcd) spin_unlock_irqrestore(&hsotg->lock, flags); dwc2_port_resume(hsotg); } else { + /* Wait for controller to correctly update D+/D- level */ + usleep_range(3000, 5000); + /* * Clear Port Enable and Port Status changes. * Enable Port Power. @@ -2479,7 +2482,7 @@ static int _dwc2_hcd_resume(struct usb_hcd *hcd) dwc2_writel(HPRT0_PWR | HPRT0_CONNDET | HPRT0_ENACHG, hsotg->regs + HPRT0); /* Wait for controller to detect Port Connect */ - mdelay(5); + usleep_range(5000, 7000); } return ret;