From: Christian Lamparter Date: Sun, 8 May 2016 13:08:22 +0000 (+0200) Subject: gpio: dt-bindings: add wd,mbl-gpio bindings X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=5b64250b614a9d3dff380035be17811cd479d8e8;p=deliverable%2Flinux.git gpio: dt-bindings: add wd,mbl-gpio bindings This patch adds the device tree bindings for the Western Digital's MyBook Live memory-mapped GPIO controllers. The gpios will be supported by gpio-mmio code of the GPIO generic library. Signed-off-by: Christian Lamparter Acked-by: Rob Herring Reviewed-by: Andy Shevchenko Signed-off-by: Linus Walleij --- diff --git a/Documentation/devicetree/bindings/gpio/wd,mbl-gpio.txt b/Documentation/devicetree/bindings/gpio/wd,mbl-gpio.txt new file mode 100644 index 000000000000..038c3a6a1f4d --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/wd,mbl-gpio.txt @@ -0,0 +1,38 @@ +Bindings for the Western Digital's MyBook Live memory-mapped GPIO controllers. + +The Western Digital MyBook Live has two memory-mapped GPIO controllers. +Both GPIO controller only have a single 8-bit data register, where GPIO +state can be read and/or written. + +Required properties: + - compatible: should be "wd,mbl-gpio" + - reg-names: must contain + "dat" - data register + - reg: address + size pairs describing the GPIO register sets; + order must correspond with the order of entries in reg-names + - #gpio-cells: must be set to 2. The first cell is the pin number and + the second cell is used to specify the gpio polarity: + 0 = active high + 1 = active low + - gpio-controller: Marks the device node as a gpio controller. + +Optional properties: + - no-output: GPIOs are read-only. + +Examples: + gpio0: gpio0@e0000000 { + compatible = "wd,mbl-gpio"; + reg-names = "dat"; + reg = <0xe0000000 0x1>; + #gpio-cells = <2>; + gpio-controller; + }; + + gpio1: gpio1@e0100000 { + compatible = "wd,mbl-gpio"; + reg-names = "dat"; + reg = <0xe0100000 0x1>; + #gpio-cells = <2>; + gpio-controller; + no-output; + };