From: Seungwon Jeon Date: Fri, 30 Aug 2013 15:13:09 +0000 (+0900) Subject: mmc: dw_mmc: add the capability to support hs200 mode X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=5dd63f524666d0b1d1b07da7cc993bc8fcd141a9;p=deliverable%2Flinux.git mmc: dw_mmc: add the capability to support hs200 mode As host controller can support eMMC's HS200 mode at 1.8V or 1.2V, these capability will be added. Signed-off-by: Seungwon Jeon Tested-by: Alim Akhtar Signed-off-by: Chris Ball --- diff --git a/Documentation/devicetree/bindings/mmc/synopsis-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/synopsis-dw-mshc.txt index cdcebea9c6f5..ae5f8e89e845 100644 --- a/Documentation/devicetree/bindings/mmc/synopsis-dw-mshc.txt +++ b/Documentation/devicetree/bindings/mmc/synopsis-dw-mshc.txt @@ -66,6 +66,10 @@ Optional properties: * supports-highspeed: Enables support for high speed cards (up to 50MHz) +* caps2-mmc-hs200-1_8v: Supports mmc HS200 SDR 1.8V mode + +* caps2-mmc-hs200-1_2v: Supports mmc HS200 SDR 1.2V mode + * broken-cd: as documented in mmc core bindings. * vmmc-supply: The phandle to the regulator to use for vmmc. If this is @@ -95,6 +99,7 @@ board specific portions as listed below. clock-frequency = <400000000>; num-slots = <1>; supports-highspeed; + caps2-mmc-hs200-1_8v; broken-cd; fifo-depth = <0x80>; card-detect-delay = <200>; diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c index 696bb468fc8e..d9f864fd0771 100644 --- a/drivers/mmc/host/dw_mmc.c +++ b/drivers/mmc/host/dw_mmc.c @@ -2187,6 +2187,12 @@ static struct dw_mci_board *dw_mci_parse_dt(struct dw_mci *host) if (of_find_property(np, "enable-sdio-wakeup", NULL)) pdata->pm_caps |= MMC_PM_WAKE_SDIO_IRQ; + if (of_find_property(np, "caps2-mmc-hs200-1_8v", NULL)) + pdata->caps2 |= MMC_CAP2_HS200_1_8V_SDR; + + if (of_find_property(np, "caps2-mmc-hs200-1_2v", NULL)) + pdata->caps2 |= MMC_CAP2_HS200_1_2V_SDR; + return pdata; }