From: Mark Brown Date: Tue, 19 Jun 2012 23:18:04 +0000 (+0900) Subject: ARM: S3C64XX: Dynamically allocate the IRQ range for WM8994 on Cragganmore X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=7d1d8ce5b50f4593f6d4b9d8149f978c122f617b;p=deliverable%2Flinux.git ARM: S3C64XX: Dynamically allocate the IRQ range for WM8994 on Cragganmore Use the new irqdomain support in the WM8994 driver to dynamically allocate the interrupt range for the WM8994 rather than doing it explicitly. This is more idiomatic for modern interrupt usage. Signed-off-by: Mark Brown Signed-off-by: Kukjin Kim --- diff --git a/arch/arm/mach-s3c64xx/include/mach/crag6410.h b/arch/arm/mach-s3c64xx/include/mach/crag6410.h index 4cb2f951f1e9..ec97c15b109e 100644 --- a/arch/arm/mach-s3c64xx/include/mach/crag6410.h +++ b/arch/arm/mach-s3c64xx/include/mach/crag6410.h @@ -15,7 +15,6 @@ #define BANFF_PMIC_IRQ_BASE IRQ_BOARD_START #define GLENFARCLAS_PMIC_IRQ_BASE (IRQ_BOARD_START + 64) -#define CODEC_IRQ_BASE (IRQ_BOARD_START + 128) #define PCA935X_GPIO_BASE GPIO_BOARD_START #define CODEC_GPIO_BASE (GPIO_BOARD_START + 8) diff --git a/arch/arm/mach-s3c64xx/mach-crag6410-module.c b/arch/arm/mach-s3c64xx/mach-crag6410-module.c index 497937222a29..4a83b4e7ab32 100644 --- a/arch/arm/mach-s3c64xx/mach-crag6410-module.c +++ b/arch/arm/mach-s3c64xx/mach-crag6410-module.c @@ -168,7 +168,6 @@ static struct wm8994_pdata wm8994_pdata = { .gpio_defaults = { 0x3, /* IRQ out, active high, CMOS */ }, - .irq_base = CODEC_IRQ_BASE, .ldo = { { .init_data = &wm8994_ldo1, }, { .init_data = &wm8994_ldo2, },