From: Scott Ellis Date: Wed, 10 Mar 2010 21:23:13 +0000 (-0700) Subject: spi/omap2_mcspi: Use transaction speed if provided X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=9bd4517ddc51c803784778ab52e6f0bc03b77a52;p=deliverable%2Flinux.git spi/omap2_mcspi: Use transaction speed if provided omap2_mcspi_transfer() gets called in omap2_mcspi_work() when the transaction speed_hz or bits_per_word fields are non-zero. omap2_mcspi_transfer() does not look at the speed_hz field so the override speed value is ignored. The code should probably change to one of these options. 1. Skip the call to omap2_mcsp_transfer() if the only reason was a non-zero speed_hz and it's not going to be used. 2. Use the new speed_hz value provided The patch below uses the speed_hz value. Signed-off-by: Scott Ellis Signed-off-by: Grant Likely --- diff --git a/drivers/spi/omap2_mcspi.c b/drivers/spi/omap2_mcspi.c index 87d44eeaaa7b..4dd786b99b8b 100644 --- a/drivers/spi/omap2_mcspi.c +++ b/drivers/spi/omap2_mcspi.c @@ -578,6 +578,7 @@ static int omap2_mcspi_setup_transfer(struct spi_device *spi, struct spi_master *spi_cntrl; u32 l = 0, div = 0; u8 word_len = spi->bits_per_word; + u32 speed_hz = spi->max_speed_hz; mcspi = spi_master_get_devdata(spi->master); spi_cntrl = mcspi->master; @@ -587,9 +588,12 @@ static int omap2_mcspi_setup_transfer(struct spi_device *spi, cs->word_len = word_len; - if (spi->max_speed_hz) { + if (t && t->speed_hz) + speed_hz = t->speed_hz; + + if (speed_hz) { while (div <= 15 && (OMAP2_MCSPI_MAX_FREQ / (1 << div)) - > spi->max_speed_hz) + > speed_hz) div++; } else div = 15;