From: Takashi Yoshii Date: Fri, 16 Nov 2012 01:52:49 +0000 (+0900) Subject: serial: sh-sci: support lower baud rate X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=9d482cc353bd0391730730b26e4c2938dc90e477;p=deliverable%2Flinux.git serial: sh-sci: support lower baud rate Support prescaler 1/16 and 1/64, in addition to current 1 and 1/4. Supporting below 2400bps was dropped long time ago in mainline. Since then, setting lower rate has been resulting in erroneous register value, without indicating any errors through API. This patch adds more prescaler to support lower rates again. This still doesn't check range, but we won't hit the case because even 50bps at 48MHz clock is now supported. Signed-off-by: Takashi Yoshii Signed-off-by: Shinya Kuribayashi Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c index 6c1fddb0e20a..a54c47d0fd63 100644 --- a/drivers/tty/serial/sh-sci.c +++ b/drivers/tty/serial/sh-sci.c @@ -1815,7 +1815,7 @@ static void sci_set_termios(struct uart_port *port, struct ktermios *termios, { struct sci_port *s = to_sci_port(port); struct plat_sci_reg *reg; - unsigned int baud, smr_val, max_baud; + unsigned int baud, smr_val, max_baud, cks; int t = -1; /* @@ -1849,21 +1849,18 @@ static void sci_set_termios(struct uart_port *port, struct ktermios *termios, uart_update_timeout(port, termios->c_cflag, baud); - serial_port_out(port, SCSMR, smr_val); + for (cks = 0; t >= 256 && cks <= 3; cks++) + t >>= 2; - dev_dbg(port->dev, "%s: SMR %x, t %x, SCSCR %x\n", __func__, smr_val, t, - s->cfg->scscr); + dev_dbg(port->dev, "%s: SMR %x, cks %x, t %x, SCSCR %x\n", + __func__, smr_val, cks, t, s->cfg->scscr); if (t >= 0) { - if (t >= 256) { - serial_port_out(port, SCSMR, (serial_port_in(port, SCSMR) & ~3) | 1); - t >>= 2; - } else - serial_port_out(port, SCSMR, serial_port_in(port, SCSMR) & ~3); - + serial_port_out(port, SCSMR, (smr_val & ~3) | cks); serial_port_out(port, SCBRR, t); udelay((1000000+(baud-1)) / baud); /* Wait one bit interval */ - } + } else + serial_port_out(port, SCSMR, smr_val); sci_init_pins(port, termios->c_cflag);