From: Vasanthakumar Thiagarajan Date: Thu, 13 Aug 2015 15:40:54 +0000 (+0530) Subject: ath10k: fill in wmi 10.4 command handlers for addba/delba debug commands X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=b2887410f0d00f376b250f78d34654b4ac093900;p=deliverable%2Flinux.git ath10k: fill in wmi 10.4 command handlers for addba/delba debug commands WMI 10.4 uses the same command interface as QCA988X for addba/delba debug wmi commands. Fill wmi_10_4_ops table with the functions used for QCA988X for these commands. With this change, the following debugfs entries can be used to configure the aggregation mode and to send addba request, addba response and delba respectively in manual aggregation mode for QCA99X0 chip. /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp /sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba Signed-off-by: Vasanthakumar Thiagarajan Signed-off-by: Kalle Valo --- diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c index 61af11a07b97..42c0aba04fb2 100644 --- a/drivers/net/wireless/ath/ath10k/wmi.c +++ b/drivers/net/wireless/ath/ath10k/wmi.c @@ -6597,6 +6597,10 @@ static const struct wmi_ops wmi_10_4_ops = { .gen_pktlog_enable = ath10k_wmi_op_gen_pktlog_enable, .gen_pktlog_disable = ath10k_wmi_op_gen_pktlog_disable, .gen_pdev_set_quiet_mode = ath10k_wmi_op_gen_pdev_set_quiet_mode, + .gen_addba_clear_resp = ath10k_wmi_op_gen_addba_clear_resp, + .gen_addba_send = ath10k_wmi_op_gen_addba_send, + .gen_addba_set_resp = ath10k_wmi_op_gen_addba_set_resp, + .gen_delba_send = ath10k_wmi_op_gen_delba_send, /* shared with 10.2 */ .gen_peer_assoc = ath10k_wmi_10_2_op_gen_peer_assoc,