From: Linus Walleij Date: Thu, 5 Nov 2015 09:18:14 +0000 (+0100) Subject: ARM: ux500: Assign proper sensor IRQs for Snowball X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=c80b4010d7e4a1ba2aa83928a659f4bd87c1019c;p=deliverable%2Flinux.git ARM: ux500: Assign proper sensor IRQs for Snowball The Snowball gyro and magnetometer DRDY (data ready) lines are used as interrupt triggers by the IIO subsystem, triggering new data retrieveal on edges on this signal. Thus assign them as the primary interrupt in the device tree. The "other interrupt" coming out of the sensors is for alarms and similar complex events, the DRDY is for periodic measures, which is what we want. After this the generic_buffer tool from IIO tools gives a nice stream of readings after enabling the desired channels in sysfs. Cc: Denis Ciocca Signed-off-by: Linus Walleij --- diff --git a/arch/arm/boot/dts/ste-snowball.dts b/arch/arm/boot/dts/ste-snowball.dts index e80e42163883..08f82077b64d 100644 --- a/arch/arm/boot/dts/ste-snowball.dts +++ b/arch/arm/boot/dts/ste-snowball.dts @@ -281,7 +281,8 @@ vddio-supply = <&db8500_vsmps2_reg>; pinctrl-names = "default"; pinctrl-0 = <&magneto_snowball_mode>; - gpios = <&gpio5 5 0x4>; /* DRDY line */ + interrupt-parent = <&gpio5>; + interrupts = <5 IRQ_TYPE_EDGE_RISING>; /* DRDY line */ }; l3g4200d@68 { /* Gyroscope */ @@ -292,9 +293,9 @@ vddio-supply = <&db8500_vsmps2_reg>; pinctrl-names = "default"; pinctrl-0 = <&gyro_snowball_mode>; - gpios = <&gpio5 6 0x4>; /* DRDY line */ interrupt-parent = <&gpio5>; - interrupts = <9 IRQ_TYPE_EDGE_RISING>; /* INT1 */ + interrupts = <6 IRQ_TYPE_EDGE_RISING>, /* DRDY line */ + <9 IRQ_TYPE_EDGE_RISING>; /* INT1 */ }; lsp001wm@5c { /* Barometer/pressure sensor */