From: Sujith Manoharan Date: Wed, 28 Jan 2015 12:24:26 +0000 (+0530) Subject: ath9k: Enable manual peak detect calibration X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=cfbed87b304a517af27c22a7caf2cb345cb063f9;p=deliverable%2Flinux.git ath9k: Enable manual peak detect calibration On some AR955x/QCA953x boards, noise floor calibration gets stuck and the cause is a hardware/BB issue. To fix this, peak detect calibration in the HW is disabled and is done in the driver instead. There a few differences with the calibration routine for older chips like AR9331. Signed-off-by: Sujith Manoharan Signed-off-by: Kalle Valo --- diff --git a/drivers/net/wireless/ath/ath9k/ar9003_calib.c b/drivers/net/wireless/ath/ath9k/ar9003_calib.c index 91130c0e31d3..174442beb952 100644 --- a/drivers/net/wireless/ath/ath9k/ar9003_calib.c +++ b/drivers/net/wireless/ath/ath9k/ar9003_calib.c @@ -1640,8 +1640,14 @@ static bool ar9003_hw_init_cal_soc(struct ath_hw *ah, skip_tx_iqcal: if (run_agc_cal || !(ah->ah_flags & AH_FASTCC)) { - if (AR_SREV_9330_11(ah)) - ar9003_hw_manual_peak_cal(ah, 0, IS_CHAN_2GHZ(chan)); + if (AR_SREV_9330_11(ah) || AR_SREV_9531(ah) || AR_SREV_9550(ah)) { + for (i = 0; i < AR9300_MAX_CHAINS; i++) { + if (!(ah->rxchainmask & (1 << i))) + continue; + ar9003_hw_manual_peak_cal(ah, i, + IS_CHAN_2GHZ(chan)); + } + } /* * For non-AR9550 chips, we just trigger AGC calibration