From: Russell King Date: Fri, 5 Oct 2012 23:51:17 +0000 (+0100) Subject: SERIAL: omap: remove setting of EFR SCD bit X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=d864c03bfce2449703c7f0544dac3fbaed347239;p=deliverable%2Flinux.git SERIAL: omap: remove setting of EFR SCD bit The SCD (special character detect) bit enables comparisons with XOFF2, which we do not program. As the XOFF2 character remains unprogrammed, there's little point enabling this feature along with its associated interrupt. Remove this, and ensure that the SCD bit is cleared. Signed-off-by: Russell King --- diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c index f5b2f395af2d..71f968b5504c 100644 --- a/drivers/tty/serial/omap-serial.c +++ b/drivers/tty/serial/omap-serial.c @@ -704,13 +704,8 @@ serial_omap_configure_xonxoff serial_out(up, UART_MCR, up->mcr | UART_MCR_TCRTLR); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B); serial_out(up, UART_TI752_TCR, OMAP_UART_TCR_TRIG); - /* Enable special char function UARTi.EFR_REG[5] and - * load the new software flow control mode IXON or IXOFF - * and restore the UARTi.EFR_REG[4] ENHANCED_EN value. - */ - serial_out(up, UART_EFR, up->efr | UART_EFR_SCD); + serial_out(up, UART_EFR, up->efr); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A); - serial_out(up, UART_MCR, up->mcr & ~UART_MCR_TCRTLR); serial_out(up, UART_LCR, up->lcr); } @@ -843,6 +838,7 @@ serial_omap_set_termios(struct uart_port *port, struct ktermios *termios, serial_out(up, UART_LCR, UART_LCR_CONF_MODE_B); up->efr = serial_in(up, UART_EFR); + up->efr &= ~UART_EFR_SCD; serial_out(up, UART_EFR, up->efr | UART_EFR_ECB); serial_out(up, UART_LCR, UART_LCR_CONF_MODE_A);