From: Shahed Shaikh Date: Fri, 10 Jan 2014 16:48:58 +0000 (-0500) Subject: qlcnic: Enable IPv6 LRO even if IP address is not programmed X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=e4f8bf830a55c3b5f11cdb836afb32a9a541a116;p=deliverable%2Flinux.git qlcnic: Enable IPv6 LRO even if IP address is not programmed o Enabling BIT_9 while configuring hardware LRO allows adapter to perform LRO even if destination IP address is not programmed in adapter. Signed-off-by: Shahed Shaikh Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_hw.c b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_hw.c index e96b76ddef47..6ca5e57da3da 100644 --- a/drivers/net/ethernet/qlogic/qlcnic/qlcnic_hw.c +++ b/drivers/net/ethernet/qlogic/qlcnic/qlcnic_hw.c @@ -782,8 +782,8 @@ void qlcnic_82xx_config_intr_coalesce(struct qlcnic_adapter *adapter) "Could not send interrupt coalescing parameters\n"); } -#define QLCNIC_ENABLE_IPV4_LRO 1 -#define QLCNIC_ENABLE_IPV6_LRO 2 +#define QLCNIC_ENABLE_IPV4_LRO BIT_0 +#define QLCNIC_ENABLE_IPV6_LRO (BIT_1 | BIT_9) int qlcnic_82xx_config_hw_lro(struct qlcnic_adapter *adapter, int enable) {