From: Mian Yousaf Kaukab Date: Sat, 16 May 2015 20:33:37 +0000 (+0200) Subject: usb: gadget: autoconf: net2280: match hardware and usb ep address X-Git-Url: http://drtracing.org/?a=commitdiff_plain;h=e9ab4d0ab8f5b1159558b9ab236e408d50962a00;p=deliverable%2Flinux.git usb: gadget: autoconf: net2280: match hardware and usb ep address USB3380 GPEP can be used in IN and OUT directions however, both directions should use same endpoint address. Fulfil this requirement by mapping usb endpoint to hardware endpoint with the same address. Tested-by: Ricardo Ribalda Delgado Signed-off-by: Mian Yousaf Kaukab Signed-off-by: Felipe Balbi --- diff --git a/drivers/usb/gadget/epautoconf.c b/drivers/usb/gadget/epautoconf.c index 0567cca1465e..919cdfdda78b 100644 --- a/drivers/usb/gadget/epautoconf.c +++ b/drivers/usb/gadget/epautoconf.c @@ -258,15 +258,25 @@ struct usb_ep *usb_ep_autoconfig_ss( /* First, apply chip-specific "best usage" knowledge. * This might make a good usb_gadget_ops hook ... */ - if (gadget_is_net2280 (gadget) && type == USB_ENDPOINT_XFER_INT) { - /* ep-e, ep-f are PIO with only 64 byte fifos */ - ep = find_ep (gadget, "ep-e"); - if (ep && ep_matches(gadget, ep, desc, ep_comp)) - goto found_ep; - ep = find_ep (gadget, "ep-f"); + if (gadget_is_net2280(gadget)) { + char name[8]; + + if (type == USB_ENDPOINT_XFER_INT) { + /* ep-e, ep-f are PIO with only 64 byte fifos */ + ep = find_ep(gadget, "ep-e"); + if (ep && ep_matches(gadget, ep, desc, ep_comp)) + goto found_ep; + ep = find_ep(gadget, "ep-f"); + if (ep && ep_matches(gadget, ep, desc, ep_comp)) + goto found_ep; + } + + /* USB3380: use same address for usb and hardware endpoints */ + snprintf(name, sizeof(name), "ep%d%s", usb_endpoint_num(desc), + usb_endpoint_dir_in(desc) ? "in" : "out"); + ep = find_ep(gadget, name); if (ep && ep_matches(gadget, ep, desc, ep_comp)) goto found_ep; - } else if (gadget_is_goku (gadget)) { if (USB_ENDPOINT_XFER_INT == type) { /* single buffering is enough */