ARM: OMAP2+: Remove board-omap4panda.c
We can now boot with device tree. If you don't want to update u-boot,
you can boot with appended DTB with the following instructions:
1. Make sure you have the appended DTB support in .config
CONFIG_ARM_APPENDED_DTB=y
CONFIG_ARM_ATAG_DTB_COMPAT=y
CONFIG_ARM_ATAG_DTB_COMPAT_CMDLINE_EXTEND=y
2. Build the zImage
$ ARCH=arm CROSS_COMPILE=... make zImage
3. Build the device tree blobs
$ ARCH=arm CROSS_COMPILE=... make dtbs
4. Append the correct panda dtb to zImage
Depending on your hardware it's omap4-panda.dtb, omap4-panda-a4.dtb
or omap4-panda-es.dtb.
$ cat arch/arm/boot/zImage arch/arm/boot/dts/omap4-panda-es.dtb > /tmp/appended
5. Use mkimage to produce the appended device tree uImage
$ mkimage -A arm -O linux -T kernel -C none -a 0x80008000 -e 0x80008000 \
-n "Linux" -d /tmp/appended /tmp/uImage
Signed-off-by: Tony Lindgren <tony@atomide.com
This page took 0.024781 seconds and 5 git commands to generate.