From 0aedc0085146131da5b04476aab21834b1403b31 Mon Sep 17 00:00:00 2001 From: Anton Vorontsov Date: Thu, 22 Apr 2010 19:44:47 +0400 Subject: [PATCH] powerpc/85xx: Fix P1020RDB boot hang due USB2 Since USB2 is shared with local bus, either local bus or USB2 should be disabled. By default U-Boot enables local bus, so we have to disable USB2, otherwise kernel hangs: ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver fsl-ehci fsl-ehci.0: Freescale On-Chip EHCI Host Controller fsl-ehci fsl-ehci.0: new USB bus registered, assigned bus number 1 fsl-ehci fsl-ehci.0: irq 28, io base 0xffe22000 fsl-ehci fsl-ehci.0: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected fsl-ehci fsl-ehci.1: Freescale On-Chip EHCI Host Controller fsl-ehci fsl-ehci.1: new USB bus registered, assigned bus number 2 Note that U-Boot doesn't clear 'status' property when it enables USB2, so we have to comment out the whole node. To enable USB2, one can issue 'setenv hwconfig usb2:dr_mode=' command at the U-Boot prompt. Signed-off-by: Anton Vorontsov Signed-off-by: Kumar Gala --- arch/powerpc/boot/dts/p1020rdb.dts | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/arch/powerpc/boot/dts/p1020rdb.dts b/arch/powerpc/boot/dts/p1020rdb.dts index 49848c545d86..22f64b62d7f6 100644 --- a/arch/powerpc/boot/dts/p1020rdb.dts +++ b/arch/powerpc/boot/dts/p1020rdb.dts @@ -475,6 +475,11 @@ phy_type = "ulpi"; }; + /* USB2 is shared with localbus, so it must be disabled + by default. We can't put 'status = "disabled";' here + since U-Boot doesn't clear the status property when + it enables USB2. OTOH, U-Boot does create a new node + when there isn't any. So, just comment it out. usb@23000 { #address-cells = <1>; #size-cells = <0>; @@ -484,6 +489,7 @@ interrupts = <46 0x2>; phy_type = "ulpi"; }; + */ sdhci@2e000 { compatible = "fsl,p1020-esdhc", "fsl,esdhc"; -- 2.34.1