From 7fc979a79d9b9af15052b4c7fd1debd44294ba4f Mon Sep 17 00:00:00 2001 From: Michal Kazior Date: Wed, 28 Jan 2015 09:57:28 +0200 Subject: [PATCH] ath10k: use per-vif wmm param setup if possible New wmi-tlv firmware for qca6174 supports this. This should fix issues related to multi-vif WMM. Signed-off-by: Michal Kazior Signed-off-by: Kalle Valo --- drivers/net/wireless/ath/ath10k/mac.c | 22 +++++++++++++++++----- 1 file changed, 17 insertions(+), 5 deletions(-) diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c index 62e8adc492cb..0c2ccc101176 100644 --- a/drivers/net/wireless/ath/ath10k/mac.c +++ b/drivers/net/wireless/ath/ath10k/mac.c @@ -4129,11 +4129,23 @@ static int ath10k_conf_tx(struct ieee80211_hw *hw, */ p->txop = params->txop * 32; - /* FIXME: FW accepts wmm params per hw, not per vif */ - ret = ath10k_wmi_pdev_set_wmm_params(ar, &arvif->wmm_params); - if (ret) { - ath10k_warn(ar, "failed to set wmm params: %d\n", ret); - goto exit; + if (ar->wmi.ops->gen_vdev_wmm_conf) { + ret = ath10k_wmi_vdev_wmm_conf(ar, arvif->vdev_id, + &arvif->wmm_params); + if (ret) { + ath10k_warn(ar, "failed to set vdev wmm params on vdev %i: %d\n", + arvif->vdev_id, ret); + goto exit; + } + } else { + /* This won't work well with multi-interface cases but it's + * better than nothing. + */ + ret = ath10k_wmi_pdev_set_wmm_params(ar, &arvif->wmm_params); + if (ret) { + ath10k_warn(ar, "failed to set wmm params: %d\n", ret); + goto exit; + } } ret = ath10k_conf_tx_uapsd(ar, vif, ac, params->uapsd); -- 2.34.1