From 8b0162a3dc5c30e862b7a73da29e32de3170f5e4 Mon Sep 17 00:00:00 2001 From: Felix Fietkau Date: Mon, 3 Nov 2008 11:27:38 +0100 Subject: [PATCH] ath5k: ignore the return value of ath5k_hw_noise_floor_calibration Noise floor calibration occasionally fails on Atheros hardware. This is not fatal and can happen if there's simply too much noise on the air. Ignoring the calibration error is the right thing to do here, because when the error is ignored, the hardware will still work, whereas if the error causes the driver to bail out of a bigger configuration function and does not configure the tx queues or the IMR (as is the case in reset.c), the hw no longer works properly until the next reset. Signed-off-by: Felix Fietkau Signed-off-by: John W. Linville --- drivers/net/wireless/ath5k/phy.c | 4 +--- drivers/net/wireless/ath5k/reset.c | 4 +--- 2 files changed, 2 insertions(+), 6 deletions(-) diff --git a/drivers/net/wireless/ath5k/phy.c b/drivers/net/wireless/ath5k/phy.c index 69625bf4d11c..7ba18e09463b 100644 --- a/drivers/net/wireless/ath5k/phy.c +++ b/drivers/net/wireless/ath5k/phy.c @@ -2196,9 +2196,7 @@ static int ath5k_hw_rf5110_calibrate(struct ath5k_hw *ah, return ret; } - ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq); - if (ret) - return ret; + ath5k_hw_noise_floor_calibration(ah, channel->center_freq); /* * Re-enable RX/TX and beacons diff --git a/drivers/net/wireless/ath5k/reset.c b/drivers/net/wireless/ath5k/reset.c index b51bc030da02..5003263c9ea4 100644 --- a/drivers/net/wireless/ath5k/reset.c +++ b/drivers/net/wireless/ath5k/reset.c @@ -842,9 +842,7 @@ int ath5k_hw_reset(struct ath5k_hw *ah, enum nl80211_iftype op_mode, * * XXX: Find an interval that's OK for all cards... */ - ret = ath5k_hw_noise_floor_calibration(ah, channel->center_freq); - if (ret) - return ret; + ath5k_hw_noise_floor_calibration(ah, channel->center_freq); /* * Reset queues and start beacon timers at the end of the reset routine -- 2.34.1