From 9ee32fea5fe810ec06af3a15e4c65478de56d4f5 Mon Sep 17 00:00:00 2001 From: Daniel Vetter Date: Sat, 1 Dec 2012 13:53:48 +0100 Subject: [PATCH] drm/i915: irq-drive the dp aux communication At least on the platforms that have a dp aux irq and also have it enabled - vlvhsw should have one, too. But I don't have a machine to test this on. Judging from docs there's no dp aux interrupt for gm45. Also, I only have an ivb cpu edp machine, so the dp aux A code for snb/ilk is untested. For dpcd probing when nothing is connected it slashes about 5ms of cpu time (cpu time is now negligible), which agrees with 3 * 5 400 usec timeouts. A previous version of this patch increases the time required to go through the dp_detect cycle (which includes reading the edid) from around 33 ms to around 40 ms. Experiments indicated that this is purely due to the irq latency - the hw doesn't allow us to queue up dp aux transactions and hence irq latency directly affects throughput. gmbus is much better, there we have a 8 byte buffer, and we get the irq once another 4 bytes can be queued up. But by using the pm_qos interface to request the lowest possible cpu wake-up latency this slowdown completely disappeared. Since all our output detection logic is single-threaded with the mode_config mutex right now anyway, I've decide not ot play fancy and to just reuse the gmbus wait queue. But this would definitely prep the way to run dp detection on different ports in parallel v2: Add a timeout for dp aux transfers when using interrupts - the hw _does_ prevent this with the hw-based 400 usec timeout, but if the irq somehow doesn't arrive we're screwed. Lesson learned while developing this ;-) v3: While at it also convert the busy-loop to wait_for_atomic, so that we don't run the risk of an infinite loop any more. v4: Ensure we have the smallest possible irq latency by using the pm_qos interface. v5: Add a comment to the code to explain why we frob pm_qos. Suggested by Chris Wilson. v6: Disable dp irq for vlv, that's easier than trying to get at docs and hw. v7: Squash in a fix for Haswell that Paulo Zanoni tracked down - the dp aux registers aren't at a fixed offset any more, but can be on the PCH while the DP port is on the cpu die. Reviewed-by: Imre Deak (v6) Signed-off-by: Daniel Vetter --- drivers/gpu/drm/i915/i915_dma.c | 1 + drivers/gpu/drm/i915/i915_drv.h | 4 ++ drivers/gpu/drm/i915/i915_irq.c | 6 +++ drivers/gpu/drm/i915/intel_dp.c | 79 +++++++++++++++++++++++++++------ 4 files changed, 77 insertions(+), 13 deletions(-) diff --git a/drivers/gpu/drm/i915/i915_dma.c b/drivers/gpu/drm/i915/i915_dma.c index 14d679ab52b7..93630669c6dc 100644 --- a/drivers/gpu/drm/i915/i915_dma.c +++ b/drivers/gpu/drm/i915/i915_dma.c @@ -1737,6 +1737,7 @@ int i915_driver_unload(struct drm_device *dev) intel_teardown_mchbar(dev); destroy_workqueue(dev_priv->wq); + pm_qos_remove_request(&dev_priv->pm_qos); if (dev_priv->slab) kmem_cache_destroy(dev_priv->slab); diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h index 3843383e13cc..a00ee3da632f 100644 --- a/drivers/gpu/drm/i915/i915_drv.h +++ b/drivers/gpu/drm/i915/i915_drv.h @@ -40,6 +40,7 @@ #include #include #include +#include /* General customization: */ @@ -665,6 +666,9 @@ typedef struct drm_i915_private { /* protects the irq masks */ spinlock_t irq_lock; + /* To control wakeup latency, e.g. for irq-driven dp aux transfers. */ + struct pm_qos_request pm_qos; + /* DPIO indirect register protection */ spinlock_t dpio_lock; diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c index 1e245e501e5a..58bb11b58796 100644 --- a/drivers/gpu/drm/i915/i915_irq.c +++ b/drivers/gpu/drm/i915/i915_irq.c @@ -536,7 +536,11 @@ static void gmbus_irq_handler(struct drm_device *dev) static void dp_aux_irq_handler(struct drm_device *dev) { + struct drm_i915_private *dev_priv = (drm_i915_private_t *) dev->dev_private; + DRM_DEBUG_DRIVER("AUX channel interrupt\n"); + + wake_up_all(&dev_priv->gmbus_wait_queue); } static irqreturn_t valleyview_irq_handler(int irq, void *arg) @@ -2732,6 +2736,8 @@ void intel_irq_init(struct drm_device *dev) setup_timer(&dev_priv->hangcheck_timer, i915_hangcheck_elapsed, (unsigned long) dev); + pm_qos_add_request(&dev_priv->pm_qos, PM_QOS_CPU_DMA_LATENCY, 0); + dev->driver->get_vblank_counter = i915_get_vblank_counter; dev->max_vblank_count = 0xffffff; /* only 24 bits of frame count */ if (IS_G4X(dev) || INTEL_INFO(dev)->gen >= 5) { diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c index b51043e651b5..ada1b316195c 100644 --- a/drivers/gpu/drm/i915/intel_dp.c +++ b/drivers/gpu/drm/i915/intel_dp.c @@ -322,6 +322,48 @@ intel_dp_check_edp(struct intel_dp *intel_dp) } } +static uint32_t +intel_dp_aux_wait_done(struct intel_dp *intel_dp, bool has_aux_irq) +{ + struct intel_digital_port *intel_dig_port = dp_to_dig_port(intel_dp); + struct drm_device *dev = intel_dig_port->base.base.dev; + struct drm_i915_private *dev_priv = dev->dev_private; + uint32_t ch_ctl = intel_dp->output_reg + 0x10; + uint32_t status; + bool done; + + if (IS_HASWELL(dev)) { + switch (intel_dig_port->port) { + case PORT_A: + ch_ctl = DPA_AUX_CH_CTL; + break; + case PORT_B: + ch_ctl = PCH_DPB_AUX_CH_CTL; + break; + case PORT_C: + ch_ctl = PCH_DPC_AUX_CH_CTL; + break; + case PORT_D: + ch_ctl = PCH_DPD_AUX_CH_CTL; + break; + default: + BUG(); + } + } + +#define C (((status = I915_READ(ch_ctl)) & DP_AUX_CH_CTL_SEND_BUSY) == 0) + if (has_aux_irq) + done = wait_event_timeout(dev_priv->gmbus_wait_queue, C, 10); + else + done = wait_for_atomic(C, 10) == 0; + if (!done) + DRM_ERROR("dp aux hw did not signal timeout (has irq: %i)!\n", + has_aux_irq); +#undef C + + return status; +} + static int intel_dp_aux_ch(struct intel_dp *intel_dp, uint8_t *send, int send_bytes, @@ -333,11 +375,17 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, struct drm_i915_private *dev_priv = dev->dev_private; uint32_t ch_ctl = output_reg + 0x10; uint32_t ch_data = ch_ctl + 4; - int i; - int recv_bytes; + int i, ret, recv_bytes; uint32_t status; uint32_t aux_clock_divider; int try, precharge; + bool has_aux_irq = INTEL_INFO(dev)->gen >= 5 && !IS_VALLEYVIEW(dev); + + /* dp aux is extremely sensitive to irq latency, hence request the + * lowest possible wakeup latency and so prevent the cpu from going into + * deep sleep states. + */ + pm_qos_update_request(&dev_priv->pm_qos, 0); if (IS_HASWELL(dev)) { switch (intel_dig_port->port) { @@ -400,7 +448,8 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, if (try == 3) { WARN(1, "dp_aux_ch not started status 0x%08x\n", I915_READ(ch_ctl)); - return -EBUSY; + ret = -EBUSY; + goto out; } /* Must try at least 3 times according to DP spec */ @@ -413,6 +462,7 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, /* Send the command and wait for it to complete */ I915_WRITE(ch_ctl, DP_AUX_CH_CTL_SEND_BUSY | + (has_aux_irq ? DP_AUX_CH_CTL_INTERRUPT : 0) | DP_AUX_CH_CTL_TIME_OUT_400us | (send_bytes << DP_AUX_CH_CTL_MESSAGE_SIZE_SHIFT) | (precharge << DP_AUX_CH_CTL_PRECHARGE_2US_SHIFT) | @@ -420,12 +470,8 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, DP_AUX_CH_CTL_DONE | DP_AUX_CH_CTL_TIME_OUT_ERROR | DP_AUX_CH_CTL_RECEIVE_ERROR); - for (;;) { - status = I915_READ(ch_ctl); - if ((status & DP_AUX_CH_CTL_SEND_BUSY) == 0) - break; - udelay(100); - } + + status = intel_dp_aux_wait_done(intel_dp, has_aux_irq); /* Clear done status and any errors */ I915_WRITE(ch_ctl, @@ -443,7 +489,8 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, if ((status & DP_AUX_CH_CTL_DONE) == 0) { DRM_ERROR("dp_aux_ch not done status 0x%08x\n", status); - return -EBUSY; + ret = -EBUSY; + goto out; } /* Check for timeout or receive error. @@ -451,14 +498,16 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, */ if (status & DP_AUX_CH_CTL_RECEIVE_ERROR) { DRM_ERROR("dp_aux_ch receive error status 0x%08x\n", status); - return -EIO; + ret = -EIO; + goto out; } /* Timeouts occur when the device isn't connected, so they're * "normal" -- don't fill the kernel log with these */ if (status & DP_AUX_CH_CTL_TIME_OUT_ERROR) { DRM_DEBUG_KMS("dp_aux_ch timeout status 0x%08x\n", status); - return -ETIMEDOUT; + ret = -ETIMEDOUT; + goto out; } /* Unload any bytes sent back from the other side */ @@ -471,7 +520,11 @@ intel_dp_aux_ch(struct intel_dp *intel_dp, unpack_aux(I915_READ(ch_data + i), recv + i, recv_bytes - i); - return recv_bytes; + ret = recv_bytes; +out: + pm_qos_update_request(&dev_priv->pm_qos, PM_QOS_DEFAULT_VALUE); + + return ret; } /* Write data to the aux channel in native mode */ -- 2.34.1