From b69d2ad6748e2cd3a6b93fca074adc31f56e4436 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Thu, 8 May 2014 23:16:37 +0200 Subject: [PATCH] mfd: stmpe: mask off unused blocks properly The STMPE driver would just read/modify/write the system control register on the STMPE1601, meaning it would not properly mask off the PWM block, which remained active if it was on at boot time. This makes sure the blocks are always masked off if they were active on boot, saving some power. Also rename the inconsistenty named STMPE1601 define for the PWM block activation. Signed-off-by: Linus Walleij --- drivers/mfd/stmpe.c | 9 +++++++++ drivers/mfd/stmpe.h | 2 +- 2 files changed, 10 insertions(+), 1 deletion(-) diff --git a/drivers/mfd/stmpe.c b/drivers/mfd/stmpe.c index 4a91f6771fb8..9fa2dd6d38bd 100644 --- a/drivers/mfd/stmpe.c +++ b/drivers/mfd/stmpe.c @@ -605,9 +605,18 @@ static int stmpe1601_enable(struct stmpe *stmpe, unsigned int blocks, if (blocks & STMPE_BLOCK_GPIO) mask |= STMPE1601_SYS_CTRL_ENABLE_GPIO; + else + mask &= ~STMPE1601_SYS_CTRL_ENABLE_GPIO; if (blocks & STMPE_BLOCK_KEYPAD) mask |= STMPE1601_SYS_CTRL_ENABLE_KPC; + else + mask &= ~STMPE1601_SYS_CTRL_ENABLE_KPC; + + if (blocks & STMPE_BLOCK_PWM) + mask |= STMPE1601_SYS_CTRL_ENABLE_SPWM; + else + mask &= ~STMPE1601_SYS_CTRL_ENABLE_SPWM; return __stmpe_set_bits(stmpe, STMPE1601_REG_SYS_CTRL, mask, enable ? mask : 0); diff --git a/drivers/mfd/stmpe.h b/drivers/mfd/stmpe.h index 6639f1b0fef5..9e4d21d37a11 100644 --- a/drivers/mfd/stmpe.h +++ b/drivers/mfd/stmpe.h @@ -192,7 +192,7 @@ int stmpe_remove(struct stmpe *stmpe); #define STMPE1601_SYS_CTRL_ENABLE_GPIO (1 << 3) #define STMPE1601_SYS_CTRL_ENABLE_KPC (1 << 1) -#define STMPE1601_SYSCON_ENABLE_SPWM (1 << 0) +#define STMPE1601_SYS_CTRL_ENABLE_SPWM (1 << 0) /* The 1601/2403 share the same masks */ #define STMPE1601_AUTOSLEEP_TIMEOUT_MASK (0x7) -- 2.34.1